What's this?
For Other Inks | Home | To Order | Other Cartridge Instructions

Bulk Ink Refill Instructions

Updated April 7, 2006

HP #95 C8766W Tri-Color Cartridge

  • #93 Tri-Color Cartridge
  • #135 C8766H Tri-Color Cartridge
  • #343 C8766E Tri-Color Cartridge
  • #855 C8766Z Tri-Color Cartridge
  • Inks

    • Cyan (blue) WJ-244
    • Magenta (red) WJ-6053
    • Yellow WJ-7006


    The ink in this cartridge is retained because the cartridge has an internal sponge. This cartridge is physically identical with the #28 C8728AN cartridge. HP puts less ink into this cartridge when new.

    Step 1) Put the cartridge on some paper towels in an area where you can tolerate a spill.

    Step 2) Remove the label on the top of the cartridge. You will find 5 holes.

    Step 3) Put the holes on top of the cartridge. Turn the cartridge so that the single hole is farthest away from you and the other 4 holes are closest to you. You may fill through any of the following holes:

    • The single hole farthest from you.
    • The hole closest to you on left.
    • The hole closest to you on right.
    To determine which color goes into which hole, insert an unbent paper clip into the hole you'd like to fill. See what color comes up!

    Step 4) Keeping the cartridge on paper towels, take a syringe bottle and fill it 1/5 full of ink -- about 6 ml. When new, the cartridge holds 7 x 3 = 21 ml. When full, the cartridge holds 14 x 3 = 42 ml.

    Step 5) Insert the needle fully into the hole. Get the tip of the needle to the bottom of the cartridge. Inject the ink very S-L-O-W-L-Y and watch until the sponge is saturated. You must get the needle deep into the hard sponge.

    Step 6) It is not necessary to reseal the holes.

    Step 7) Set above a paper towel for an hour as a drip precaution, perhaps over a small cup. Expect a few drips. Do not allow the cartridge to touch the paper towel at this point, since the towel will draw out the ink.

    Step 8) For best results, let sit overnight before using. Tape over the vent holes if you plan to store for awhile to prevent drying out of the ink.

    If you have a leak

    There are only 2 reasons to have a leak with this cartridge:
    1. The cartridge has been overfilled. Remove some of the ink or let sit until it stabilizes.
    2. The cartridge has been damaged severely on the bottom. This should be obvious. Throw away the cartridge.

    If the Cartridge doesn't Print

    This simple cartridge is merely a sponge-filled box. Try the following:
    1. Be sure that you have put the ink into the bottom of the sponge inside the cartridge. If you don't get the ink to the bottom, the cartridge won't print.

    2. Follow the directions in the printer manual to run the cleaning routine. This cleaning routine is in the HP Toolbox software.

    3. If this doesn't work, take the cartridge to the nearest hot water faucet.
      • Turn on the hot water. Let it get hot.
      • Put only the printhead portion (where the ink comes out) under the hot water for 2 to 3 seconds -- NOT 10 seconds!!!.
      • Dry off the cartridge using a soft tissue.
      • Re-insert the cartridge into the printer.
      • Run the normal cleaning software routine a few times.

    4. If this doesn't work, remove the syringe needle from the syringe. Set the needle aside. Go to the sink. Put your fingers over 4 of the 5 holes. Using the syringe, squeeze air gently into the 5th hole to pressurize the cartridge, and (hopefully) push ink to the bottom of the cartridge and out the printhead. This is messy!

    5. If the cartridge has been sitting in your drawer for a couple weeks or more, it is probably dry. If so, you may need to rinse out the sponge with warm water injected repeatedly into the cartridge. After rinsing out the cartridge, let dry by putting in front of an air conditioner or warm air vent for several hours. Then attempt to refill normally.

    6. If this doesn't work, soak only the printhead in simmering water for up to 2 hours. You may add up to 50 percent ammonia for really tough clogs.

    To Clean Your Sink

    The ink is water-soluble. Use plenty of soap and warm water. You may also need to use Comet or a similar cleaner if the stains persist.

    To Clean Your Hands

    On hands, the best substance to use is Ink Be GoneTM, a specially developed hand cleaner available from ACSI Bulk Inks. (To place an order, Click Here.)

    To Place An Ink Order

    You can telephone us at 1-888-728-2465 (USA Tollfree) or 1+740-374-9949. You can also Order Online or by other ways including by Fax, or by Postal Mail, or by EMAIL.
    What's this?
    Copyright 2004, Automation Consulting & Supply, Inc.
    Contact us at 1-304-622-5086 or email us at Order Email.
    Main Ink Page | Other Refill Instructions and Help | Home